FICHA DEL PRODUCTO:

ULTRA VITRODUR BRILLANTE

1 PRODUCT DESCRIPTION
Hard-wearing and highly resistant polymer sealer for the protection of vinyl, linoleum and resin floors (after installation or following stripping). The floor is protected, dirt adhesion is reduced and routine cleaning is facilitated.
 Suitable for renovating care-film in a high-speed process.
 Creates a shiny, nonslip protective film ensuring a high degree of safety when walking on the treated surface.
2 AREAS OF APPLICATION
Vinyl and linoleum floors. Use on rubber floors is possible only under certain circumstances and should be checked
before use.
Please pay attention to our technical instructions specifically for floors and buildings under www.dr-schutz.com

3 METHOD OF APPLICATION
Shake High Shine Hard Sealer Wet Look well before use. Then apply an even, thin, undiluted coat lengthways to the surface of the cleaned floor (after installation or stripped), using the Polish Applicator System or the Quick Step System. When the protective film is firm to walk on (after approximately 1 hour), repeat the procedure in the crossways direction. Allow the film to dry for at least 12 hours before the floor is walked on, better still would be
overnight.
Note: Ensure that there is sufficient ventilation but avoid exposure to drafts and strong sunlight during application and drying processes and protect the surface from dust. Turn off under-floor central heating in good time prior to use. In isolated cases, the coating may powder in the case of porous old linoleum floor coverings that have been leached out through the use of strongly alkaline cleaning products. Extended exposure to standing saltwater kann lead to a bleaching of the polymer seal. This bleaching can usually be attributed to the formation of salt crusts and can be removed with Dr. Schutz Active Cleaner R280.

4 CONSUMPTION
1 l = 20 m² per coat.

5 STORAGE
Keep locked up and out of the reach of children. Protect agains frost.

6 TECHNICAL DATA
Data on ingredients (EC recommendation): Contains BENZISOTHIAZOLINONE,
METHYLISOTHIAZOLINONE, perfumes, LIMONENE, solvents, care-componenets.
Product code for cleaning and care products (Giscode): GE 10 pH-level: 8.5 (concentrate) ADR/RID: not a dangerous good as defined by transport regulations.
CLP: The product is not classified according to the CLP regulation. EUH208 Contains reaction mass of: 5-chloro-2- methyl-4-isothiazolin-3-one [EC no. 247-500-7] and 2- methyl-2H-isothiazol-3-one [EC no. 220-239-6] (3:1). May produce an allergic reaction.
Completely emptied canisters can be disposed of in domestic waste, or taken to a recycling centre.

7 SPECIAL NOTES
Please pay attention to our technical instructions specifically for floors and buildings under www.dr-schutz.com

8 CROSS-REFERENCE
Our following publications in their updated form are valid as an integral part of this fact sheet:
– General notes on the application of Dr. Schutz finishes
– Safety data sheet available on request.
The quoted printed matter, as well as this product information in its updated form, is available on our homepage
www.dr-schutz.com or on request from the address quoted below.

Nuestra oficina

Puigbarral, 34, Nave D, P.I. Can Petit

E-08227 Terrassa, Barcelona

Horario

Lunes-Viernes: 8:00 – 14:00