FICHA DEL PRODUCTO:

LIMPIADOR PU

1 PRODUCT DESCRIPTION
Concentrated Cleaner for use on new floors immediately after installation and for the routine cleaning of floors
factory-cured with a polyurethane finish as well as vinyl, linoleum or rubber floor coverings treated with PU Sealer.
– Excellent dirt-binding properties, even in the case of fatty deposits.
– Causes no damage to the floor surface, does not cause greying (development of grey filming).
– Does not leave a residue.
– Complies with the requirements of DIN 18032 for floors in sports areas, gyms, etc.

2 AREAS OF APPLICATION
Floors factory-cured with a polyurethane finish as well as vinyl, linoleum or rubber floor coverings treated with PU Sealer.
Please pay attention to our technical instructions specifically for floors and buildings under www.dr-schutz.com

3 APPLICATION
Cleaning after installation:
Remove coarse dirt using a brush or vacuum cleaner. In case of stubborn dirt, dilute PU Cleaner in a ratio of 1:10
(1 litre to 10 litres of water), reducing the concentration accordingly for slight soiling. Distribute the cleaning solution over the floor and, after allowing to stand for a short time, treat the floor surface using a Monodisc appliance and red pad or scrubbing brush. Take up the dirt using a Dr. Schutz Spray extractor fitted with a hard floor adapter or absorbent wide-headed wiper mop and wipe over with clear water to neutralise.
Daily Cleaning:
Dilute PU Cleaner in a ratio of 1:200 (50 ml to 10 litres of water) and wipe over the floor using this solution. The concentration can be reduced to 1:400 (25 ml to 10 litres of water) when using a fully automatic cleaning appliance.
Note: Sensitive surfaces (such as wood, metal, furnishings) should not be sprayed with the cleaning solution.

4 CONSUMPTION
Cleaning after installation: ca. 2 litres per 100 m² Daily Cleaning : ca. 0,1 litres per 100 m²

5 STORAGE
Store in cool, dry conditions in well sealed receptacles. Store under lock and key and out of the reach of children.

6 TECHNICAL DATA
Ingredients: contains under 5% anionic tensides, under 5% non ionic tensides. Contains perfumes (LIMONENE),
solvants. pH value: 9,5 (concentrate)
ADR/RID: no dangerous good according ADR CLP: GHS07. Danger. H319 Causes serious eye irritation.
P101 If medical advice is needed, have product container or label at hand P102 Keep out of reach of children. P280
Wear protective gloves/protective clothing/eye protection/face protection.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes Remove contact lenses, if present
and easy to do. Continue rinsing.P337+P313 If eye irritation persists Get medical advice/attention P501 Dispose of contents/container in accordance with local/regional/national/international regulations.
Even when using low-pollution products, the usual safety measures are to be observed. Keep away from children.
Completely emptied canisters can be disposed of in domestic waste, or taken to a recycling centre.

7 SPECIAL NOTES
Please pay attention to our technical instructions specifically for floors and buildings under www.dr-schutz.com

8 CROSS-REFERENCE
Our following publications in their updated form are valid as an integral part of this fact sheet:
– General notes on the application of Dr. Schutz finishes
– Safety data sheet available on request.
The quoted printed matter, as well as this product information in its updated form, is available on our homepage
www.dr-schutz.com or on request from the address quoted below.

Nuestra oficina

Puigbarral, 34, Nave D, P.I. Can Petit

E-08227 Terrassa, Barcelona

Horario

Lunes-Viernes: 8:00 – 14:00