FICHA DEL PRODUCTO:

LIMPIADOR R 1000

1 PRODUCT DESCRIPTION
Special wipe-over care product for the routine cleaning and care of resilient floors. Based on water-soluble environmental friendly care components. Cleans and protects the floor in one step. Creates an antislip and satin protective film. Application concentration pH neutral. Can be used in combination with a cleaning machine such as the Premium F 2. Also recommended for the initial protection of structured rubber floors.
– Creates a mat, anti-slip and anti-static protective film ensuring a high degree of safety when walking on
the treated surface.
– Excellent dirt-binding properties, even with greasy residues.
– Complies with the requirements of DIN 18032 for floors in sports areas, gyms, etc.

2 AREAS OF APPLICATION
Vinyl, linoleum and rubber floors. Complies with the requirements of DIN 18032 for floors in sports areas, gyms, etc.
Please pay attention to our technical instructions specifically for floors and buildings under www.dr-schutz.com.

3 METHOD OF APPLICATION
Initial care in high traffic areas: If no polymer dispersion can be used for the initial care of the floor, dilute R 1000
Floor Cleaner in a ratio of 1:10 (1 l to 10 l of water) and wipe over the cleaned floor with the solution. Polish up the resultant protective film with the Monodisc SRP 2+S with polishing pad or polishing brush.
Routine cleaning and care: Dilute R 1000 Floor Cleaner in a ratio of 1:200 (50 ml to 10 l of water) and wipe over the floor with this solution. Leave to dry remaining moisture. Cleans and protects the floor in one step. The dilution can be increased up to 1:400 (25 ml to 10 l of water) for grained floors and in cleaning machines.
Note: Regular polishing increases the resistance of the protective coating especially in high traffic areas. Pay
attention to exact quantities. Repeated over-dosage of R 1000 Floor Cleaner or the accumulation of moisture on the treated surface can lead to an increase in surface friction and thus to a reduction in anti-slip qualities.

4 CONSUMPTION
Initial care: 1 l = 50 m²
Routine cleaning: 1 l = 1000 m²

5 STORAGE
Floor Cleaner R 1000 should be stored in a cool, dry place in its closed original container. Keep locked up and out
of the reach of children. Protect from frost.

6 TECHNICAL DATA
Data on ingredients (EC recommendation): less than 5% anionic surfactants. Contains BENZISOTHIAZOLINONE,
METHYLISOTHIAZOLINONE, perfumes, LIMONENE, solvents, care-componenets.
Product code for cleaning and care products (Giscode): GU 50. pH: 9.5 (concentrate) ADR/RID: not a dangerous good as defined by transport regulations.
CLP: The product is not classified according to the CLP regulation.
Even when using low-pollution products, the usual safety measures are to be observed. Completely emptied
canisters can be disposed of in domestic waste, or taken to a recycling centre.
7 SPECIAL NOTES
Please pay attention to our technical instructions specifically for floors and buildings under www.dr-schutz.com.


8 CROSS-REFERENCE

Our following publications in their updated form are valid as an integral part of this fact sheet:
– General notes on the application of Dr. Schutz finishes
– Safety data sheet available on request.
The quoted printed matter, as well as this product information in its updated form, is available on our homepage
www.dr-schutz.com or on request from the address quoted below

Nuestra oficina

Puigbarral, 34, Nave D, P.I. Can Petit

E-08227 Terrassa, Barcelona

Horario

Lunes-Viernes: 8:00 – 14:00